Cisco AS5350XM Configuration Manual page 55

Universal gateways software configuration guide
Hide thumbs Also See for AS5350XM:
Table of Contents

Advertisement

Verifying Basic Setup
AS5400# show health-monitor summary
Chassis:
Power Supply
Temperature
Fans
Memory:
Free Memory processor
Memory Fragmentation Processor
Free Memory I/O
Memory Fragmentation I/O
DFC's:
Slot 1 (NP108 DFC)
Slot 2 (NP108 DFC)
Slot 3 (NP108 DFC)
Slot 4 (NP60 DFC)
Slot 5 (NP108 DFC)
Slot 7 (CT3 DFC)
Using the Interface Queue Wedge Monitor
The Interface Queue Wedge Monitor displays information about interface queue wedges and the times
that they occur. An interface queue is wedged when the packet count that is being transmitted (output
queue) or received (input queue) is equal to or greater than the maximum packet count size of the queue,
and consequently, no more packets are transmitted or received.
The Interface Queue Wedge Monitor is enabled or disabled using following commands.
The Interface Queue Wedge Monitor is disabled by default.
When the Interface Queue Wedge Monitor is enabled, it monitors all the input and output queue wedge
interfaces. The show wedged-interfaces [output/input] command displays the queue wedged
interfaces.
The show wedged-interfaces output command displays the output queue wedge interfaces and their
respective time-since-wedges.
The show wedged-interfaces input command displays the input queue wedge interfaces and their
respective time-since-wedges.
Interface Queue Wedge Output Procedure
When the Interface Queue Wedge Monitor is enabled, and an interface (such as a GigabitEthernet0/0
output queue is already wedged, the following message is displayed on the console, syslog, and buffer:
Eg:
The following procedure shows an example of how to enable, disable, and show the results of a wedged
interface output:
Enable the Interface Queue Wedge Monitor.
Step 1
AS5400# configure terminal
Enter configuration commands, one per line.
AS5400#(config)# interface-monitor enable
AS5400#(config)# ^Z
interface-monitor enable
[no] interface-monitor enable
00:39:15: %HHM-3-INTFWEDGE: GigabitEthernet0/0 Output Queue Wedged
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
Using the Interface Queue Wedge Monitor
Failure
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
End with CNTL/Z.
11

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

As5400xm

Table of Contents