Cisco AS5350XM Configuration Manual page 190

Getting Started
Repeat
Step 21
Enter yes to configure the GigabitEthernet0/0 interface to connect the gateway to a LAN, and then
Step 22
respond to the remaining questions to configure the Gigabit Ethernet port.
Do you want to configure GigabitEthernet0/0
Use the 100 Base-TX (RJ-45) connector? [yes]:
Note
Operate in full-duplex mode? [no]:
Operate at 100 Mbps speed? [yes]:
Configure IP on this interface? [yes]:
IP address for this interface [X.X.X.X]: 172.22.50.10
Subnet mask for this interface [255.255.0.0] :
Class B network is 172.22.0.0, 16 subnet bits; mask is /16
Repeat
Step 23
Step 24 Configure your serial interfaces by responding to the following prompts:
Do you want to configure Serial0/0
Configure IP on this interface? [no]: yes
Configure IP unnumbered on this interface? [no]:
Repeat
Step 25
After you complete the configuration script, the setup script displays the configuration command script.
Go to the
Step 26
Cisco AS5350XM or Cisco AS5400XM with AS54-DFC-8CT1
To use the setup script on the gateway configuring two AS54-DFC-8CT1 trunk cards and five
AS54-DFC-108NP universal port cards, take the following steps.
Step 1 Power up the gateway. The power switch is on the rear panel, at the upper right corner near the power
cord, as shown in
Messages begin to appear in your terminal emulation program window.
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
6
Step 15 to Step 20 to configure the remaining controllers.
Full-duplex mode enables simultaneous data transfer between a sending and a receiving station.
Step 22 to configure any other Gigabit Ethernet ports, if necessary.
Assign to which interface [GigabitEthernet0/0]:
Step 24 to configure any other serial interfaces, if necessary.
"Save the Configuration File" section on page
Figure 7.
interface? [yes]: yes
interface? [no]: yes
14.