Cisco AS5350XM Configuration Manual page 161

Configuring Voice over IP
Dial-Peer Configuration Table
The next step in creating dial peers is to create a dial-peer configuration table. Under the following
headings, show data for all of your gateways and associated dial peers.
gateway-to-gateway scenario described earlier; your own will be far more complex.
Table 18
Dial-Peer
Tag
San Jose Gateway
1
2
Newark Gateway
3
4
Tip Consult the references at the end of the chapter before you create a dial-peer configuration table. See
also Voice over IP for the Cisco AS5300, available online at
http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/120newft/120t/120t3/voip5300/
Configuring Echo Cancellation on the Voice Feature Card
The echo-cancel enable command enables cancellation of voice that is sent out the interface and
received back on the same interface; sound that is received back in this manner is perceived by the
listener as an echo. Disabling echo cancellation might cause the remote side of a connection to hear an
echo. Because echo cancellation is an invasive process that can minimally degrade voice quality, this
command should be disabled if it is not needed.
For the voice feature card, software echo cancellation is the default configuration—G.168-compliant
echo cancellation is enabled by default with a coverage of 64 milliseconds. Hardware echo cancellation
is not available.
Configure
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Dial-Peer Configuration Table
Destination
Extension Pattern
5000 5000
— 6...
— 5...
6000 6000
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
Type Voice Port Session Target Codec
pots 1/0:1 —
voip — 172.16.1.1
voip — 172.19.1.1
pots 1/0:3 —
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
•
Enters global configuration mode.
Configuring Basic VoIP
Table 18 is for the simple
QoS
— —
6.711 best effort
6.711 best effort
— —
11