Cisco AS5350XM Configuration Manual page 192

Getting Started
Cisco AS5400XM (BCM) processor (revision 0x21) with 393215K/131072K bytes of memory.
Processor board ID JAB082904P4
SB-1 CPU at 750MHz, Implementation 1025, Rev 0.3, 256KB L2 Cache
Last reset from IOS reload
Manufacture Cookie Info:
EEPROM Version 0x4, Board ID 0x4BD,
Board Hardware Version 1.11, Item Number 800-6572289-01,
Board Revision 02, Serial Number JAB082904P4.
Processor 0x0, MAC Address badb.adba.d044
2 Gigabit Ethernet interfaces
6 Serial interfaces
648 terminal lines
1 Channelized T3 port
512K bytes of NVRAM.
125184K bytes of ATA External CompactFlash (Read/Write)
Press RETURN to get started!
Step 2 When the following message appears, enter yes to continue:
Would you like to enter the initial configuration dialog? [yes/no]: yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Step 3 When the following message appears, enter no to configure all interfaces. Note that if you enter yes, your
system will not be configured correctly.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system
Would you like to enter basic management setup? [yes/no]: no
Step 4 When the following message appears, enter no to bypass the current interface summary:
First, would you like to see the current interface summary? [yes]: no
Enter a hostname for the gateway.
Step 5
Configuring global parameters:
Enter host name [Router]: AS5400
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when you
Step 6
view the configuration.
Enter enable secret: lab
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter an enable password. This password is not encrypted (less secure) and can be seen when you view
Step 7
the configuration.
Enter enable password: guessme
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
8