Troubleshooting - Cisco AS5350XM Configuration Manual

Troubleshooting

SPE Configuration Mode
SPE configuration mode allows you to configure SPEs, similar to line configuration mode. You can
configure an SPE by specifying a slot and an SPE associated with the slot or, you can choose to configure
a range of SPEs by specifying the first and last SPE in the range.
The following example demonstrates how to enter SPE configuration mode.
AS5400# configure terminal
Enter configuration commands, one per line.
AS5400(config)# spe 1/1 1/17
AS5400(config-SPE)#
SPE Configuration Mode Commands
The following commands are available in SPE configuration mode:
•
•
•
•
Troubleshooting
This section provides troubleshooting information that applies to your modems regardless of service
type mode. You learn how to perform diagnostic tests on installed ports or SPEs, configure automatic
recovery of ports on an SPE, and configure a scheduled recovery of SPEs.
Configure SPE Diagnostic Tests
You can perform three types of diagnostic tests on your SPE modem:
•
•
•
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
8
firmware location—Allows you to transfer a specified version of SPE firmware from system flash
memory to the SPEs named upon entering SPE configuration mode. For further information on
firmware upgrades, see the
firmware upgrade busyout | download-maintenance | reboot—Allows you to specify the upgrade
method. Three methods of upgrade are available.
Busyout (the default) upgrades when all calls are terminated on an SPE.
–
Download-maintenance waits to upgrade at the next download maintenance. For further
–
information on firmware upgrades, see the
default download-maintenance time is 0300.
Reboot upgrades at the next reboot. Note that for the firmware upgrade reboot command to
–
take effect after a reload, you must have saved the running configuration with the copy
running-config startup-config command.
busyout—Gracefully disables an SPE by waiting for all the active services on the specified SPE to
terminate. If there are active ports on the specified SPE, the state of the SPE is changed to Busiedout.
The SPE is temporarily disabled. Use the no form of this command to reenable the SPEs.
shutdown—Clears active calls on all ports on the SPE. Calls can no longer be placed on the SPE
because the SPE state is changed to Out-of-Service. The state of the SPEs is reflected in the show
spe command display. Use the no form of this command to reenable the ports on the SPE.
SPE startup test
SPE autotest
SPE back-to-back test
Managing and Troubleshooting the Universal Port and Dial-Only Feature Cards
End with CNTL/Z.
"Upgrading SPE Firmware" section on page
"Upgrading SPE Firmware" section on page
11.
11. The