Cisco AS5350XM Configuration Manual page 113

Continuing Configuration Using the Command-Line Interface
If you are having trouble:
•
•
•
Saving Configuration Changes
To prevent the loss of the gateway configuration, save it to NVRAM.
Configure
Command
Step 1
AS5350> enable
Password: password
AS5350#
Step 2
AS5350# copy running-config startup-config
Step 3
AS5350(config-if)# Ctrl-Z
AS5350#
Where to Go Next
At this point you can go to these references:
•
•
•
The following publications are available on the Documentation DVD, on the World Wide Web from the
Tip
Cisco home page, or you can order printed copies.
•
•
Make sure the cable connections are not loose or disconnected.
Make sure you are using number 12 or 14 AWG copper wires to connect to the alarm port terminal
blocks.
Make sure your alarm is operational.
Chapter 5, "Managing and Troubleshooting the Universal Port and Dial-Only Feature Cards,"
configure, manage, and troubleshoot universal port and dial-only feature card connections on your
gateway.
Chapter 6, "Managing and Troubleshooting the Voice Feature Card,"
troubleshoot voice feature card connections on your gateway.
Appendix C, "Comprehensive Configuration Examples."
For additional basic configuration information, see the Cisco IOS Dial Technologies Configuration
Guide and Cisco IOS Dial Technologies Command Reference publications for your software release.
For more advanced configuration topics, see the Cisco IOS software configuration guide, feature
modules, and command reference publications that pertain to your Cisco IOS software release.
For troubleshooting information, see the System Error Messages and Debug Command Reference
publications.
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
Saving Configuration Changes
Purpose
Enters enable mode (also called privileged EXEC
mode) and enters the password. You are in enable
mode when the prompt changes to
.
AS5400#
Saves the configuration changes to NVRAM so
that they are not lost during resets, power cycles,
or power outages.
Returns to enable mode.
to configure, manage, and
or
AS5350#
to
11