Cisco AS5350XM Configuration Manual page 143

Managing and Troubleshooting the Voice Feature Card
AS5400(config)# Ctrl-Z
AS5400#
Save your changes.
Step 10
AS5400# copy running-config startup-config
Using DSP Firmware Bundled with Cisco IOS Software
Use this procedure to update DSP firmware on the DSPs in your gateway if the DSPs are currently
configured with any non-bundled DSP firmware version.
This process does not delete any existing DSP firmware that resides in system flash memory in case you
Note
later want to revert to it. If you decide to delete the code from system flash memory, remember that all
files in system flash memory are deleted; therefore, save and restore any important files (for example,
the Cisco IOS software image).
If the new Cisco IOS image contains the same DSP firmware as the old one, no new code is downloaded
Note
to the DSPs.
To set the DSP firmware to the DSP firmware version bundled with Cisco IOS software, enter the
following commands:
Enter the enable command.
Step 1
AS5400> enable
Enter your password.
Step 2
Password: password
AS5400#
You are in privileged EXEC mode when the prompt changes to
Enter global configuration mode by typing the configure terminal command.
Step 3
AS5400# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
AS5400(config)#
You are in global configuration mode when the prompt changes to
Step 4 Enter DSP configuration mode. You can either delete the configuration for a single DSP, or a range of
DSPs by specifying the first and last DSP in the range. The DSP firmware used by the DSPs
automatically reverts to the version bundled with the current Cisco IOS image.
AS5400(config)# voice dsp slot/dsp
or
AS5400(config)# voice dsp slot/dsp slot/dsp
You are in DSP configuration mode when the prompt changes to
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
Upgrading DSP Firmware
or
AS5350# AS5400#.
or
AS5350(config)# AS5400(config)#
AS5400(config-voicedsp)#
.
.
7