Cisco AS5350XM Configuration Manual page 117

Managing and Troubleshooting the Universal Port and Dial-Only Feature Cards
Viewing SPE Performance Statistics
You can view SPE statistics using the Cisco IOS software with the gateway. To view performance
statistics for the universal port or dial-only feature cards, enter one or more of the following commands
in privileged EXEC mode (at the
show spe voice Commands
•
•
The dial-only feature card only supports dial services. Dial services include modem calls (all
Note
modulations), ISDN digital calls, V.110 data calls, and V.120 data calls. Modem pass-through calls are
not included in dial services.
show spe digital Commands
•
•
•
•
show spe modem Commands
•
•
•
•
show spe voice active—Displays the active statistics of all SPEs, a specified SPE, or a specified
SPE range serving voice traffic.
show spe voice slot | slot/spe summary—Displays the history statistics of all SPEs in a particular
slot, specified SPE, or specified SPE range serving voice traffic.
show spe digital active—Displays the active statistics of all SPEs, a specified SPE, or a specified
SPE range serving digital traffic.
show spe digital csr—Displays the digital call success rate statistics for a specific SPE, range of
SPEs, or all the SPEs.
show spe digital disconnect-reason—Displays the digital disconnect reasons for the specified SPE
or SPE range. The disconnect reasons are displayed with Class boundaries.
show spe digital slot | slot/spe summary—Displays the history statistics of all SPEs in a particular
slot, specified SPE or the specified SPE range serving digital traffic.
show spe modem active—Displays the active statistics of all SPEs, a specified SPE, or a specified
SPE range serving modem traffic. It is used in the same way as the show modem command is used
for MICA modems. (The show modem command is not supported on the Cisco AS5350XM or
Cisco AS5400XM universal gateway.)
show spe modem csr—Displays the call success rate statistics for a specific SPE, range of SPEs, or
all the SPEs.
show spe modem disconnect-reason—Displays the reason for disconnection for the specified SPE
or SPE range. Disconnection reasons are displayed with class boundaries. This command is used in
the same way as the show modem call-stats command is used for MICA modems. (The show
modem call-stats command is not supported on the Cisco AS5350XM or Cisco AS5400XM
universal gateway.)
show spe modem {high | low} speed—Shows the connection speeds negotiated within each high
or low speed modulation or codecs for a specific range of SPEs or all the SPEs.
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
or prompt):
AS5350# AS5400#
Configuring SPE Performance Statistics
3