Cisco AS5350XM Configuration Manual page 67

Basic Configuration Using the Command-Line Interface
Configure
Command
Step 1
AS5400> enable
Password: password
AS5400#
Step 2
AS5400# configure terminal
Enter configuration commands, one per line.
End with CNTL/Z.
AS5400(config)#
Step 3
AS5400(config)# interface group-async 1
AS5400(config-if)#
Step 4
AS5400(config-if)# group-range slot/port
slot/port
Building configuration...
AS5400(config-if)#
Step 5
AS5400(config-if)# Ctrl-Z
AS5400#
Verify
To verify your group interface configuration enter the show interface async command to check whether
the protocol is up:
AS5400# show interface async 4/0
Async4/00 is down, line protocol is down
modem(slot/port)=4/0, state=IDLE
dsx1(slot/unit/channel)=NONE, status=VDEV_STATUS_UNLOCKED
Hardware is Async Serial
MTU 1500 bytes, BW 115 Kbit, DLY 100000 usec,
Encapsulation SLIP, loopback not set
DTR is pulsed for 5 seconds on reset
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/10/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
5 minute input rate 0 bits/sec, 0 packets/sec
reliability 255/255, txload 1/255, rxload 1/255
Conversations 0/1/32 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
Available Bandwidth 86 kilobits/sec
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
Configuring the Asynchronous Group Interface
Purpose
Enters the enable command. Enters your
password. You are in privileged EXEC mode when
the prompt changes to
AS5350#
Enters global configuration mode. You are in
global configuration mode when the prompt
changes to
AS5540(config)#
AS5350(config)#.
Enters interface configuration mode, and places
all asynchronous interfaces in a single group, so
that you configure the same parameters quickly on
all interfaces at one time.
Defines the slot/port group range of the interface.
The range that you specify depends on the number
of asynchronous interfaces you have on your
gateway. If your gateway has 108 asynchronous
interfaces, you can specify group-range 1/1
1/107.
Returns to enable mode.
or .
AS5400#
or
7