Using The Cli - Cisco AS5350XM Configuration Manual

Using the CLI

Changing the Default Settings for a Console or AUX Port
There are only two changes that you can make to a console port and an AUX port:
•
•
The AUX port on the Route Processor (RP) installed in a Cisco ASR1000 series router does not serve
Note
any useful customer purpose and should be accessed only under the advisement of a customer support
representative.
Using the CLI
This section describes the following topics:
•
•
•
•
•
•
•
•
•
•
•
Understanding Command Modes
The CLI command mode structure is hierarchical, and each mode supports a set of specific commands.
This section describes the most common of the many modes that exist.
Table 1
brief description of how each mode is used.
ii
Change the port speed with the config-register 0x command. Changing the port speed is not
recommended. The well-known default speed is 9600.
Change the behavior of the port; for example, by adding a password or changing the timeout value.
Understanding Command Modes, page ii
Using the Interactive Help Feature, page v
Understanding Command Syntax, page vi
Understanding Enable and Enable Secret Passwords, page viii
Using the Command History Feature, page viii
Abbreviating Commands, page ix
Using Aliases for CLI Commands, page ix
Using the no and default Forms of Commands, page x
Using the debug Command, page x
Filtering Output Using Output Modifiers, page x
Understanding CLI Error Messages, page xi
lists common command modes with associated CLI prompts, access and exit methods, and a
Using the Command-Line Interface in Cisco IOS and Cisco IOS XE Software