Table of Contents
Advertisement
31. Finish up
31.1. Remove the protective film from the screens
Gently remove the protective film from all screens.
31.2. Cleaning
Both the screens and the steel structure are sensitive to fingerprints and
probably requires some cleaning.
Cleaning the screens:
•
Be sure that the screen is not connected to power.
•
Use a soft and dry cloth such as superfine fibers or cotton flannels. The
surface of the product and the display are vulnerable to scratches.
•
Do not apply chemicals containing alcohol, solvent, or surfactant such as
wax, benzene, thinner, pesticide, air freshener, lubricant, or cleaner to the
product.
Steel and aluminum parts:
•
Apply a small amount of non-alcohol-based cleaning agents onto a soft,
clean, lint-free cloth, and gently wipe the surface.
Cosmetic wall:
•
Cleanings is done by dry mop or vacuum. Use synthetic cleaning fluid
without ammonia for greasy stains, fruit, wine and coffee. Blood is removed
with cold water.
•
The UV coated and laminate surfaces are approved for hospital cleaning
products containing up to 70% alcohol.
You can read our general guidelines on how to clean or disinfect Cisco Room
devices here:
https://help.webex.com/n6biz7y/
31.3. Connect to network and power
1. Use the handle to pull down the right screen.
2. Connect the network cable to the wall outlet (P1).
3. Connect power cables to the socket outlets in the right power cavity (S8,
S9, X4, P2).
4. Use the handle to push the right screen up in place.
5. Use the handle to pull down the left screen.
6. Connect power cables to the socket outlets in the left power cavity (D4, D5,
S7).
7. The following components have a power switch. They should be On:
•
Codec
•
Camera
•
24 V PSU (the largest PSU in the left power cavity)
8. Use the handle to push the left screen up in place.
9. Connect the Ethernet switch under the table to power (X2).
10. The screens should automatically power up. If they don't, use the remote
control or power button to switch them on.
•
Main screens: power button below the logo (lower right)
•
Content screen: power button (lower center)
Allow the system to initialize. Some components may have to reboot. This may
take several minutes.
31.4. What's next
Follow the instructions in the Getting Started Guide to finalize the installation.
These steps are mandatory:
1. Register the system
2. Follow the Setup assistant (on the touch controller)
3. Calibrate all screens
Download the Getting Started Guide from here:
https://www.cisco.com/go/panorama-installation
93
Advertisement
Table of Contents
