Mount The Codec And Amplifier - Cisco Room Panorama Installation Manual

7. Mount the codec and amplifier

The codec and amplifier are placed in the
rack cavity. The connector panels are facing
upward.
Codec and amplifier
1x
codec C2
1x
amplifier with rack ears C3
2x
rack ears A6
8x
(M5x10, Torx 25)
7.1. Mount the codec
1. Remove the eight pre-mounted screws
, put the rack ears in place, and
(Hex 2 mm)
fasten them using the same screws and screw
holes.
2. Remove the rubber feet from the codec.
3. Slide the codec into its slot. Fasten it
with four screws
(M5x10, Torx 25)
×2
.
23