Table of Contents
Advertisement
19.11. Align the upper panels
There are two adjustment screws and one support screw below each upper front panel. These screws are
for aligning the upper panels and make the split lines between panels as tight and even as possible.
Support screws
(one on each profile)
Adjust the screws until the panels are level at top, and the split lines are tight and even:
1. Loosen, without removing, the support screws so that they do not interfere when aligning the
2. Tighten or loosen the adjustment screws on both profiles until you are satisfied with the alignment.
3. Finally, adjust the support screws to fit with the new and aligned position of the panels.
If it is impossible to align the panels, you may try to adjust the screw that you entered in Step 19.1 as well.
Adjustment screws
(two on each profile)
panels.
57
Advertisement
Table of Contents
