Table of Contents
Advertisement
12.1. Loudspeaker cables
1. Connect cable bundles
A1
(left) and
the diagram.
2. Attach the cables to the hooks above the amplifier with velcro.
3. Leave ends marked S1-S6 and S7-S12 on top of the cavities:
•
S1-S6 to the left
•
S7-S12 to the right
4. Hang ends marked SB1-SB4 down behind the rack cavity, and
them to the
subwoofers.
•
SB1-SB2 to the left
•
SB3-SB4 to the right
SB1
SB2
5. Fasten the subwoofer cables to the bottom of the display cavities with
velcro to prevent the cables and connectors from touching the subwoofers.
Touching the subwoofers may cause rattling noise.
30
C6
A2
(right) to the amplifier as shown in
SB3
SB4
12.2. Power cable for the Ethernet switch in the system
1. Connect the power cable (X4) to the Ethernet switch in the system.
The power socket is facing downward, so you must connect it from below.
2. Lead the cable through the hole toward the right power cavity.
Don't connect it to the socket outlet now.
3. Fasten the cable to the bottom of the display cavity with velcro to prevent
the cable from touching the subwoofers and causing rattling noise.
connect
Make sure to leave enough slack so that it is possible to lift the switch out of
the cavity later, without disconnecting the power cable.
C7
Advertisement
Table of Contents
