Pull Up And Connect The Cables Between The System And Components On The Table - Cisco Room Panorama Installation Manual

28. Pull up and connect the cables between the system and components on the table

Note: If you have chosen not to use the flex tubes, you must route the cables (X1, T1...3) from the table to the codec through the hole in the back wall of the rack cavity,
connect them as shown in the wiring diagram, and strap them with velcro or cable ties for strain relief.
Cables toward the table
C6
You must pull the cables between the system and the table
through the flex tubes that you installed in step 15.
You need a nylon draw tape or similar when pulling the cables
up the tubes from below.
Flex tubes:
Ethernet cable for the Ethernet switch by the table (X1) and
HDMI presentation cables (T1...3). The number of presentation
cables depends on your order.
1. Bundle these cables together and pull them up the flex
tube with a nylon draw tape.
2. Connect the cables to the codec as shown in the wiring
diagram.
3. Strap the cables with velcro or cable ties for strain relief.
4. Leave the other end of the cables on the floor for now.
90
C7