15. Mount the flex tubes for cables
Two flex tubes run from the rack cavity toward the
floor. You need them to route the cables between
the codec and the components on the table,
across the floor.
Alternatively, you can route these cables through
the hole in the back wall of the rack cavity, through
the wall, under the floor or above the ceiling, and
toward the table. In this case, you don't need to
install the flex tubes.
Flex tubes
2x
flex tubes
A6
2x
tube adapter
A6
6x
cable tie
A6
38
1. Add an adapter to both tubes and tighten.
2. Unscrew and remove the nut from the
adapters.