Table of Contents
Advertisement
19.8. Mount the upper corner panels
Repeat the procedure on both sides.
1. Add a screw with spacer to the upper panel
lock
(M4x12, Torx 20; Nylon spacer, 5 mm)
The left and right panel locks are marked with
L and R, respectively.
54
2. Place the panel lock onto the upper corner
.
panel.
The left and right panel locks are not identical.
Take care to put them in the correct position
(right side shown in illustration).
Make sure to fit the hooks fully into the groove
of the panel, and check that the screw with
spacer enters the corresponding slot at the
rear side of the panel.
3. Place the upper corner panel on top of the
lower corner panel.
Make sure to fit the groove of the panel fully
into the profiles on the joining module on all
sides. Also check that the slots at the rear side
of the panel enter the corresponding screws
with spacers.
4. Give the panel a firm push at the top, so that
the slots at the rear side of the panel enter the
corresponding screws with spacers on the
upper trim.
Advertisement
Table of Contents
