Module Programming; Add Module - Honeywell Fire-Lite Alarms MS-9600 Manual

Master Programming Level
POINT PROGRAM
SELECT TYPE
1=DETECTOR
2=MODULE
Point Program Screen #2
MS-9600 PN 51335:E1 2/14/08
As an example, the user could quickly enter 'FLR_3_ROOM_305' as follows:
1. The cursor is on the first letter of the Adjective field. Press the zero key twice to
display FLR_3
2. With the cursor on the first letter of the Noun field, press the zero key twice to
recall the display ROOM_304. The cursor automatically jumps from the first to
the last letter of the Noun field
3. With the cursor on the last letter of the Noun field, press the zero key again to
increment the room number to 305
4. Press the right arrow key to advance the zone field
5. Select a zone number from 00 to 99. Z00 (default zone) is the general alarm
zone. Z01 through Z99 may be selected to link software zones

3.6.2.2 Module Programming

Pressing 2, while viewing Point Program Screen #2, will allow the programmer to
add, delete or change the programming of an addressable module. The following
screen will be displayed by the control panel:
1=ADD
2=DELETE
3=EDIT

3.6.2.2.1 Add Module

Pressing 1 while viewing the Modules Screen will display the following screen
which allows the programmer to add a new module address to programming:
ENTER MODULE#
***
Add Module Screen #1
A flashing cursor will appear in the position of the first asterisk to the left. The
programmer keys in the three digit module address, such as 005.
MODULES
Modules Screen
ADD MODULE
Programming
59