10: Password Change - Honeywell Fire-Lite Alarms MS-9600 Manual

Master Programming Level
PROGRAMMING
1=PASSWORD CHANGE
2=CLEAR PROGRAM
3=PROGRAM CHECK
Programming Screen #4
MS-9600 PN 51335:E1 2/14/08
Pressing the number key corresponding to the desired baud rate (2 for 4800 Baud
for example) will program the control panel for the selected baud rate and return the
display to the Option Module Screen which will indicate Printer/PC PR4800 for a
supervised printer installed at 4800 baud rate.
Pressing 3 while viewing the Printer-PC Screen will program the control panel for a
PC connection. The display will return to the Option Module Screen which will
indicate Printer/PC PC for personal computer installed.
3.6.10 Password Change
The factory set passwords, which have been programmed into the control panel, can be
changed by selecting the Password Change option. Pressing 1 while viewing
Programming Screen #4 will cause the following screen to be displayed:
PASSWORD CHANGE
1=MASTER
2=MAINTENANCE
Press 1 to change the Master Programming Level password or 2 to change the
Maintenance Level password. Note that the passwords will not be displayed on
LCD-80F annunciators.
The following screen will appear when either change option is selected:
ENTER NEW FIVE DIGIT
Enter Password Screen
A flashing cursor will appear in the center of the display. Enter a new five digit
password (such as 10101 for the Master Level). After the fifth digit is entered, the
following screen will be displayed:
NEW MASTER
PASSWORD IS
PRESS ENTER IF OK
Pressing the Enter key will program the new password into the control panel and return
the display to the Password Change Screen.
Password Change Screen
PASSWORD
10101
Password Change Screen
Programming
99