Time-Date; Time - Honeywell Fire-Lite Alarms MS-9600 Manual

Master Programming Level
SYSTEM SETUP
1=TROUBLE REM
2=BANNER

3=TIME-DATE

System Setup Screen #1
MS-9600 PN 51335:E1 2/14/08
These screens allow the programmer to enter a two line custom banner. A flashing
cursor will appear in the bottom left corner of each display. A maximum of 20
characters (including spaces) can be entered into each screen for a total of two lines
with 40 characters. After entering up to 20 characters in the first screen, press Enter
to view the second screen. Enter up to 20 characters in the second screen in the
same manner or just press Enter if a second banner line is not being entered. To
quickly clear the current banner, press the CLR key.
To enter alphanumeric characters from the keypad, repeatedly press the appropriate
key until the desired character is displayed in the first position. For example, to
enter the letter B, press the 2 (ABC) key three times to toggle through the characters
1, A and B. Press the right arrow key to move the cursor one position to the right
and repeat the process to enter the next character. To enter a space, press the * (QZ)
key four times to place a blank in the desired position. When all characters have
been entered, press Enter to store the information and return to the Banner Screen.
3.6.5.3 Time-Date
The control panel time and date can be changed by pressing 3 while viewing the
System Setup Screen #1. The following screen will be displayed:
TIME AND DATE

1=TIME

2=DATE
3=CLOCK FORMAT
Time-Date Screen #1
TIME AND DATE
1=DAYLIGHT SAVINGS
Time-Date Screen #2
3.6.5.3.1 Time
To change the time, press 1 while viewing the Time-Date Screen. The following
screen will be displayed:
ENTER TIME
10:00 AM
1=AM
A flashing cursor is located toward the top left of the display. Below the cursor is
the current time. To change the time, enter the two-digit hours followed by the two-
digit minutes. The cursor will move one position to the right each time a digit is
entered. After the last minutes digit is entered, the cursor will again move one
position to the right. At this point enter 1 for AM or 2 for PM. The display will
then return to the Time-Date Screen which will show the new time entry. If an error
is made while entering a digit, press the CLR key to delete the entire entry and
beginning again.
10:00 AM
04-07-2000
12HR
2=PM
Time Screen
Programming
83