Table of Contents
Advertisement
Screen Display For Various Numbers Of Active Sensors
The AreaRAE Plus/Pro can display readings from one to eight sensors, plus four meterology
sensors (wind speed, wind direction, temperature, relative humidity) depending on the AreaRAE
Plus/Pro's configuration. In order to maximize readability and the amount of information
shown, the display is automatically reconfigured, according to the number and types of sensors
in the AreaRAE Plus/Pro.
Glance Mode
Glance Mode allows you to get vital information without turning on the AreaRAE Plus/Pro. You
can check information such as the instrument's model and serial number, installed sensor types,
wireless modules installed, etc., which may help when taking inventory of instruments and their
sensors or when working with service or support personnel. Glance Mode can be
enabled/disabled via Safety Suite Device Configurator (SSDC).
Enter Glance Mode
Note: The instrument must be configured so that Glance Mode is turned on (the default mode is
"Off"). This can be done in Safety Suite Device Configurator (SSDC).
With the AreaRAE Plus/Pro turned off, press and hold [Y/+] to enter Glance Mode. The feature is
latched, meaning that it runs even after you release the [Y/+] key. If you see the message
"GLANCE DISABLED," you must configure the instrument to use Glance Mode.
If Glance Mode is enabled, the first screen is displayed. After releasing [Y/+], other screens can
be displayed by pressing the [N/-] Key. In Safety Suite Device Configurator (SSDC), Glance Mode
can be enabled or disabled by checking or unchecking the box labeled "Enable Glance Mode."
Screens
Every screen displayed in sequence as configuration. Press [N/-] to advance to the next screen.
Press [MODE] to exit Glance Mode. The screens are shown in sequence.
AreaRAE
25
User Manual
Advertisement
Table of Contents
