Table of Contents
Advertisement
To change the pump Speed or Stall Algorithm setting:
1.
Press [MODE]. Either the pump Speed or the Stall Algorithm is highlighted.
2.
To change from "High" to "Low" or "Dynamic" to "Static," press [Y/+].
Important! The pump Speed must be set to "High" in order to access Dynamic pump stall
settings.
Now follow directions to change the pump stall threshold values, using the method that matches
your choice of either Dynamic or Static.
Setting Pump Stall Threshold Values – Dynamic Method
When the Dynamic pump stall threshold values are shown, you can perform calibration to set
the pump stall values dynamically.
Press [MODE] to begin calibration. This screen is shown, indicating that it is ready:
AreaRAE
126
User Manual
Advertisement
Table of Contents
