Table of Contents
Advertisement
Buzzer
l
All Disabled
l
Comfort Beep
A Comfort Beep is a single beep of the audible alarm at 60-second intervals that informs the
person using the AreaRAE Plus/Pro that it is functioning. It can be turned on or off.
Datalog
The instrument displays a floppy disk icon to indicate that a datalog is being recorded. The
instrument stores the measured gas concentration for each sensor, date and time for each
measurement, Site ID, User ID, and other parameters. The AreaRAE Plus/Pro memory is
sufficient to record six months' worth of data for 12 sensors and GPS at one-minute intervals,
24/7. All data are retained (even after the unit is turned off) in non-volatile memory so that they
can be downloaded at a later time to a PC.
Clear Datalog
This operation erases all data stored in the datalog. Select "Clear Datalog," and then "Yes."
Note: Once the datalog is cleared, the data cannot be recovered.
Datalog Interval
Intervals are shown in seconds. The default value is 60 seconds. The maximum interval is 3600
seconds, and the minimum is 1 second.
AreaRAE
68
User Manual
Advertisement
Table of Contents
