Status Display Of The Outputs - Honeywell ESSER 8010 Operation And Installation Instructions Manual

2.1.2 Status display of the outputs

The status of the corresponding zone or of the output is alternatively indicated with the 13 LED. The status of
the 13 zones is shown in normal operation. The output indication is activated by pressing the >Switchover< key.
The green LED >Output< of the status display lits to confirm the activated output indication.
Switchover
With the key >Switchover< , it is possible to switch between indicating the zones or outputs
(Toggle operation).
Status display of the outputs is
switched on
Fig. 3: Status display of the outputs (Example with Output No. 7)
Outputs no.1 to no.13 (yellow LED)
Off Normal operation, the output is in the resting state
Flashes Output failure
On Output deactivated
Twinkle Input check -the output number was entered via the control panel keypad
Disconnected or zones in trouble will not signal an alarm in case of an event!
FB 798955.GB0 / 09.07
Extinguishing Control Computer 8010 – 19-Inch
In operation
Extinguishing system
activated
Extinguishing system
enabled
Emergency release
Switching off
Test operation
Extra releasing 1
Outputs
Alarm
Detector zone
1 2 3 4 5 6 7 8
9 10 11 12 13
Fire/Switch off/Trouble
7