Honeywell LMB HYPER 120-03 Component Maintenance Manual With Illustrated Parts List page 99

SUBTASK 21-22-91-410-003-A01
For PNR 00001059 Amdt B
(5) Installation of the Control Board (01-330A)
(Ref. IPL Fig. 01)
(Ref. Fig. 7004)
(a)
(b)
(c)
(d)
(e)
(f)
(g)
(h)
(i)
(j)
SUBTASK 21-22-91-410-003-B01
For PNR 00001059 Amdt C
(6) Installation of the Control Board (01-330B)
(Ref. IPL Fig. 01)
(Ref. Fig. 7004)
(a)
(b)
(c)
(d)
(e)
(f)
(g)
The document reference is online, please check the correspondence between the online documentation and the printed version.
COMPONENT MAINTENANCE MANUAL
Put the control board (01-330A) in position in the control board support (01-320A).
Apply a layer of adhesive material (M38B) on the thread of the screws (01-340).
Attach the control board (01-330A) to the control board support (01-320A) with the three
washers (01-350) and the three screws (01-340) .
Torque the screws (01-340) to the specified value (Ref. TASK 21-22-91-820-802-A01).
Solder the other end of the yellow wire (01-790) on the control board (01-330A) with
solder material (M60X) (Ref. Fig. 7004).
Clean the solder and apply a layer of varnish SCC3 (MXXD).
Bond the yellow wire (01-790) on the control board (01-330A) with a spot of adhesive
material (M81B) close to the solder.
Put the Control S/A (01-290A) in position on the tie-rods (01-440).
Apply a layer of adhesive material (M38B) on the thread of the three tie-rods (01-440).
Attach the Control S/A (01-290A) with the three washers (01-310) and the three nuts
(01-300).
Put the control board (01-330B) in position in the control board support (01-320B).
Apply a layer of adhesive material (M38B) on the thread of the screws (01-340).
Attach the control board (01-330B) to the control board support (01-320B) with the three
washers (01-350) and the three screws (01-340) .
Torque the screws (01-340) to the specified value (Ref. TASK 21-22-91-820-802-A01).
Solder the other end of the yellow wire (01-790) on the control board (01-330B) with
solder material (M60X) (Ref. Fig. 7004).
Clean the solder and apply a layer of varnish SCC3 (MXXD).
Bond the yellow wire (01-790) on the control board (01-330B) with a spot of adhesive
material (M81B) close to the solder.
00001059
21-22-91
Page 7013
Dec 15/06