Honeywell LMB HYPER 120-03 Component Maintenance Manual With Illustrated Parts List page 89

CAUTION: HOLD STRONGLY THE EQUIPPED HOUSING DURING THE INSTALLATION OF
(f)
(g)
CAUTION: BEFORE THE INSTALLATION OF THE OUTER REAR FLANGE (01-560), CHECK
(h)
(i)
(j)
(k)
(l)
(m)
(n)
(o)
(p)
(q)
(r)
The document reference is online, please check the correspondence between the online documentation and the printed version.
COMPONENT MAINTENANCE MANUAL
THE ROTOR.
Install the rotor (01-630) in the equipped housing (01-640) with the rotor installation
guide (T05).
Apply a layer of adhesive material (M38B) on the threaded part of the screws (01-570).
IF THE THREE HOLES FOR THE TIE RODS (01-440) ARE OPENED UP TO THE
STATOR SIDE, THIS WILL AFFECT THE INSTALLATION OF THE TIE RODS
(01-440) (REF. SUBTASK 21-22-91-410-002-A01).
Put the outer rear flange (01-560) in position against the rear bearing.
NOTE: Refer to Fig. 7001 detail A for the orientation of the outer rear flange (01-560).
Put the stator wires through the dedicated ports of the outer rear flange (01-560).
Attach the outer rear flange (01-560) with the four screws (01-570).
Torque the screws (01-570) to the specified value (Ref. TASK 21-22-91-820-802-A01)
Install the outer front flange (01-550) and the retaining ring (01-540).
NOTE: Make sure that the rotor (01-630) turns freely.
Install the six spring washers (01-530) against the rear bearing (01-620) (Ref. Fig.
7001 detail B).
Install the inner rear flange (01-550) and the retaining ring (01-540).
Apply a layer of adhesive material (M38B) on the threaded part of the screws (01-610).
Attach the inner front flange (01-600) with the three screws (01-610) and the three
washers (01-620).
NOTE: Put a long M3 screw or an M3 threaded rod in one hole of the inner front flange
(01-600) to pull it close to the equipped housing (01-640).
Torque the screws (01-610) to the specified value (Ref. TASK 21-22-91-820-802-A01)
Do a check of the pressure of the spring washers (01-530).
– Put the comparator sensor against the inner rear flange (01-520).
– Apply a pressure of 2,50 ± 0,20 kg to the inner rear flange (01-520).
– Make sure that the inner rear flange (01-520) starts moving at this value.
– If necessary, add one more spring washer (01-530) as shown on detail B (Ref. Fig.
7001).
00001059
21-22-91
Page 7003
Dec 15/06