Honeywell LMB HYPER 120-03 Component Maintenance Manual With Illustrated Parts List page 96

(u) If the wires are new, cut them at 45 mm (1.772 in) from the power board (01-370) and
crimp them on 3 mm (0.118 in).
(v) Solder all the wires on the power board (01-370) (Ref. Fig. 7003).
(w) Clean the solders and apply a layer of varnish SCC3 (MXXD).
(x) Cut a 80 mm (3.15 in) length of yellow wire (01-790) and crimp it on 3 mm (0.118
in) on the both sides.
(y) Solder the yellow wire (01-790) on the power board (01-370) with solder material (M60X)
(Ref. Fig. 7004).
(z) Clean the solder and apply a layer of varnish SCC3 (MXXD).
(aa) Bond the yellow wire (01-790) on the power board (01-370) with a spot of adhesive
material (M81B) close to the solder.
The document reference is online, please check the correspondence between the online documentation and the printed version.
COMPONENT MAINTENANCE MANUAL
00001059
21-22-91
Page 7010
Dec 15/06