Honeywell LMB HYPER 120-03 Component Maintenance Manual With Illustrated Parts List page 88

CODE REFERENCE
M38B LOCTITE 243
M81B DP110
M82B DP490
MXXC GREASE ASONIC 240 GLY32
MXXD VARNISH SCC3
M60X SOLDER B.SN60PB40
(3) Referenced Information
REFERENCE
GRAPHIC-21-22-91-991-022-A01
GRAPHIC-21-22-91-991-013-A01
GRAPHIC-21-22-91-991-014-A01
GRAPHIC-21-22-91-991-015-A01
GRAPHIC-21-22-91-991-016-A01
GRAPHIC-21-22-91-991-017-A01
GRAPHIC-21-22-91-991-018-A01
GRAPHIC-21-22-91-991-019-A01
TASK-21-22-91-200-801-A01
TASK-21-22-91-820-802-A01
C. Job Set-up
Do the checking procedures (Ref. TASK 21-22-91-200-801-A01) before assembly.
D. Procedure
SUBTASK 21-22-91-410-001-A01
(1) Assembly of the Equipped Rotor
(Ref. IPL Fig. 01)
(Ref. Fig. 7001)
(a) Install the inner front flange (01-600) on the rotor (01-630).
(b) Apply a layer of lubricating material (MXXC) on the bearings seats of the rotor (01-630).
(c) Install the bearings (01-590) on the rotor (01-630) with the press punch adaptor (T03) and
the press punch socket (T04).
(d) Set the O-ring (01-580) in the outer rear flange (01-560).
(e) Apply a layer of lubricating material (MXXC) in the bores of the equipped housing (01-640)
and of the outer rear flange (01-560).
The document reference is online, please check the correspondence between the online documentation and the printed version.
COMPONENT MAINTENANCE MANUAL
00001059
DESIGNATION
ADHESIVE MATERIAL
ADHESIVE MATERIAL
ADHESIVE MATERIAL
LUBRICATING MATERIAL
VARNISH MATERIAL
SOLDER MATERIAL
PAGE
BLOCK
10000
7000
7000
7000
7000
7000
7000
7000
5000
8000
DESIGNATION
IPL FIGURE 1
FIGURE 7001
FIGURE 7002
FIGURE 7003
FIGURE 7004
FIGURE 7005
FIGURE 7006
FIGURE 7007
INSPECTION/CHECK
TIGHTENING TORQUES
21-22-91
Page 7002
Dec 15/06