Cleaning Of Component Parts; Reason For The Job; Job Set-Up Information; Job Set-Up - Honeywell LMB HYPER 120-03 Component Maintenance Manual With Illustrated Parts List

TASK 21-22-91-100-803-A01
3.

Cleaning of Component Parts

A.

Reason for the Job

WARNING: – DO NOT BREATHE THE FUMES. THE SOLVENTS ARE DANGEROUS.
CAUTION:
Self-explanatory
B.

Job Set-up Information

(1) Referenced Information
REFERENCE
TASK-21-22-91-100-804-A01
C. Job Set-up
Not applicable
D. Procedure
SUBTASK 21-22-91-160-003-A01
(1) Cleaning of the Component Parts
(a)
(b)
(c)
E.

Close-up

Not applicable
The document reference is online, please check the correspondence between the online documentation and the printed version.
COMPONENT MAINTENANCE MANUAL
– USE EYE PROTECTION. DO NOT LET THE SOLVENTS TOUCH YOUR SKIN.
– CLEAN THE PARTS IN A ROOM WHERE AIRFLOW IS SUFFICIENT.
– DO NOT CLEAN NEAR AN OPEN FLAME.
– CAREFULLY OBEY THE CLEANING PROCEDURES, OR REPLACE THEM WITH
A PROCEDURE WHICH IS SPECIFIED BY THE MANUFACTURER IF YOU USE
EQUIVALENT PRODUCTS.
– AFTER YOU COMPLETE THE PROCEDURE, YOU MUST PUT PROTECTIVE
CAPS OR APPLICABLE PACKAGING MATERIAL ON THE PARTS.
PAGE BLOCK
4000
Clean each part to remove oil, grease and dirt.
Make sure that the mating areas are fully free from packing material or sealing compound.
Use the applicable cleaning procedure (Ref. TASK 21-22-91-100-804-A01).
00001059
DESIGNATION
CLEANING PROCEDURE TABLE
21-22-91
Page 4003
Dec 15/06