Honeywell LMB HYPER 120-03 Component Maintenance Manual With Illustrated Parts List page 79

TASK 21-22-91-100-808-A01
8. Procedure 4: Cleaning of Parts with Alcohol-Based Cleaning Agent
A. Reason for the Job
WARNING: – DO NOT BREATHE THE FUMES. THE SOLVENTS ARE DANGEROUS.
CAUTION:
(1) This procedure is specially applicable to:
– hardware electrical component parts,
– electronic component parts,
– printed circuits.
B. Job Set-up Information
(1) Consumable Materials
CODE REFERENCE
M09A DENATURED METHANOL (OM23214)
(a)
(b)
C. Job Set-up
Not applicable. Use the cleaning material as it is.
D. Procedure
WARNING: – IN WORKSHOPS, KEEP THE ALCOHOL-BASED CLEANING AGENTS IN SMALL
SUBTASK 21-22-91-110-003-A01
(1) Cleaning
(a)
(b)
E. Close-up
Not applicable
The document reference is online, please check the correspondence between the online documentation and the printed version.
COMPONENT MAINTENANCE MANUAL
– USE EYE PROTECTION. DO NOT LET THE SOLVENTS TOUCH YOUR SKIN.
– CLEAN THE PARTS IN A ROOM WHERE AIRFLOW IS SUFFICIENT.
– DO NOT CLEAN NEAR AN OPEN FLAME.
– CAREFULLY OBEY THE CLEANING PROCEDURES, OR REPLACE THEM WITH
A PROCEDURE WHICH IS SPECIFIED BY THE MANUFACTURER IF YOU USE
EQUIVALENT PRODUCTS.
– AFTER YOU COMPLETE THE PROCEDURE, YOU MUST PUT PROTECTIVE
CAPS OR APPLICABLE PACKAGING MATERIAL ON THE PARTS.
Use a cleaning material which agrees with Specification MIL-A-6090.
Example: - Cleaning material (M09A).
QUANTITIES (250 CM³ (15.25 CU.IN)).
– CLEAN THE PARTS IN A ROOM WHERE AIRFLOW IS SUFFICIENT.
– DO NOT CLEAN NEAR AN OPEN FLAME OR AN INCANDESCENT MATERIAL.
Clean parts with a soft brush.
Dry with compressed air at ambient temperature.
00001059
DESIGNATION
DENATURED METHANOL
21-22-91
Page 4011
Dec 15/06