Cleaning Of A Sub-Assembly; Reason For The Job; Job Set-Up Information; Job Set-Up - Honeywell LMB HYPER 120-03 Component Maintenance Manual With Illustrated Parts List

TASK 21-22-91-100-802-A01
2.

Cleaning of a Sub-Assembly

A.

Reason for the Job

WARNING: – DO NOT BREATHE THE FUMES. THE SOLVENTS ARE DANGEROUS.
– USE EYE PROTECTION. DO NOT LET THE SOLVENTS TOUCH YOUR SKIN.
– CLEAN THE PARTS IN A ROOM WHERE AIRFLOW IS SUFFICIENT.
– DO NOT CLEAN NEAR AN OPEN FLAME.
CAUTION: – CAREFULLY OBEY THE CLEANING PROCEDURES, OR REPLACE THEM WITH
A PROCEDURE WHICH IS SPECIFIED BY THE MANUFACTURER IF YOU USE
EQUIVALENT PRODUCTS.
– AFTER YOU COMPLETE THE PROCEDURE, YOU MUST PUT PROTECTIVE
CAPS OR APPLICABLE PACKAGING MATERIAL ON THE PARTS.
Self Explanatory
B.

Job Set-up Information

(1) Referenced Information
REFERENCE
TASK-21-22-91-100-804-A01
C. Job Set-up
Not applicable
D. Procedure
SUBTASK 21-22-91-160-002-A01
(1) Cleaning of the Sub-Assembly
(a) Refer to the Cleaning Method Table (Ref. TASK 21-22-91-100-804-A01): do the
procedure which is given for the most easily damaged part.
E.

Close-up

Not applicable
The document reference is online, please check the correspondence between the online documentation and the printed version.
COMPONENT MAINTENANCE MANUAL
00001059
PAGE
BLOCK
4000
DESIGNATION
CLEANING METHOD TABLE
21-22-91
Page 4002
Dec 15/06