Table of Contents
Advertisement
Running H/F 1
Running H/F 2
CAUTION: Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations. Statement
1036
CAUTION: Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the
network interface. Statement 1037
CAUTION: To report a gas leak, do not use a telephone in the vicinity of the leak. Statement 1039
CAUTION: Do not locate the antenna near overhead power lines or other electric light or power circuits, or where it can come
into contact with such circuits. When installing the antenna, take extreme care not to come into contact with such circuits,
because they may cause serious injury or death. For proper installation and grounding of the antenna, please refer to national
and local codes (for example, U.S.:NFPA 70, National Electrical Code, Article 810, Canada: Canadian Electrical Code, Section
54). Statement 1052
CAUTION: This product is not intended to be directly connected to the Cable Distribution System. Additional regulatory
compliance and legal requirements may apply for direct connection to the Cable Distribution System. This product may connect
to the Cable Distribution System ONLY through a device that is approved for direct connection. Statement 1078
Installation Instructions
To install the Cisco 4G-ANTM-OM-CM antenna on a ceiling:
1.
Drill a 3/4" diameter hole in the ceiling where you want to mount the antenna.
2.
(Optional) Drill three pilot holes and insert the supplied screw anchors.
NOTE: You can secure the antenna in place using only the mounting nut. However, for additional support, you can also use
the supplied mounting screws. To use the mounting screws, you must first drill three pilot holes and insert the supplied
screw anchors in place.
a.
Insert the antenna's cable and thread through the hole you drilled in Step 1 until the base of the antenna is flush with
the ceiling.
b.
Using a pencil or pen, mark the screw positions on the ceiling.
c.
Remove the antenna from the ceiling.
d.
Using a 3/16" drill bit, drill three holes for the screw anchors.
e.
Properly insert the three screw anchors into the pilot holes.
3.
Insert the antenna's cable and thread through the hole you drilled in Step 1 until the base of the antenna is flush with the
ceiling.
4.
From above the ceiling:
a.
Thread the supplied flat washer through the antenna's cable and thread.
b.
Thread the supplied spring washer through the antenna's cable and thread.
c.
Thread the supplied mounting nut through the antenna's cable.
d.
Attach the mounting nut to the antenna's thread by manually turning the nut clockwise until the antenna is secured in
place.
e.
(Optional) Insert the mounting screws, then cover them with the white screw covers.
5.
Connect the antenna's cable to one of the supported extension cables.
82
Hide quick links:
Advertisement
Table of Contents
