Tools And Equipment Required - Cisco 4G-ANTM-OM-CM Manual

ANT-MP2-I-OUT-M and ANT-MP2-I-O-SS-M Antenna and Cable Kits

Tools and Equipment Required

In addition to the parts included in the antenna kit described in the section
following tool to install the antenna on the router:

Strap wrench

13 mm socket wrench
Install the Antenna onto the CGR 1240 Router
Follow these steps to install the antenna onto the router:
1. Remove the plug on the antenna connector if one is present.
2. Attach the monopole antenna to your desired antenna port. Do not tighten the antenna completely—stop tightening so that
the antenna is not fully installed.
Figure 12 Insert Base of Antenna into Router Antenna Port
3. From the chassis interior, the antenna MCX jack should be visible in the plug. With one hand, position the right-angle end
of the antenna cable to the antenna's MCX jack. With your other hand, push the cable end so it inserts into the MCX jack
of the antenna.
Integrated Antenna
430
Kits, you must provide the