Mechanical And Environmental Specifications - Cisco 4G-ANTM-OM-CM Manual

Cisco GPS Antenna (ANT-GPS-OUT-TNC)
Specification
Type
Operating frequency range
Impedance
VSWR
Gain
Minimum gain
Pattern type
Polarization
LNA gain
Front end GPS filter
Out-of-band attenuation
DC voltage
Current draw

Mechanical and Environmental Specifications

The following is a summary of the mechanical and environmental antenna specifications:
Specification
Environment
Height
Diameter (maximum, at
base)
Connector
Cable
Operating temperature
Wind speed rating
Compliance
Safety Warnings
WARNING: Avoid using or servicing any equipment that has outdoor connections during an electrical storm.
There may be a risk of electric shock from lightning. Statement 1088
WARNING: Do not work on the system, or connect or disconnect cables, during periods of lightning activity. Statement 1001
WARNING: Do not locate the outdoor antenna near overhead power lines or other electric light or power circuits, or where it can
come into contact with such circuits. When installing the antenna, take extreme care not to come into contact with such circuits,
as they may cause serious injury or death. For proper installation and grounding of the antenna, please refer to national and local
codes (for example, U.S.:NFPA 70, National Electrical Code, Article 810, Canada:Canadian Electrical Code, Section 54).
Statement 1052
Cisco GPS Antenna (ANT-GPS-OUT-TNC)
Patch, active
1575.42 MHz +/- 5 MHz
50 ohm, nominal
2.0 max. in band
4.0 dBi min. @ Zenith
1 dBi @ 10-degrees elevation
Hemispherical
Circular RHCP
25 dB +/-2 dB
This antenna features a GPS RF filter in front of the LNA to enable
co-location with other radios.
20 dB min. at 1575 +/- 50 MHz
3 to 5 VDC
20 mA max. @ 3.3 VDC +/- .3 VDC
Cisco GPS Antenna (ANT-GPS-OUT-TNC)
Outdoor (IP67)
0.87 in. (2.21 cm)
2.0 in. (5.0 cm)
Right-angle TNC(m)
LMR-100A, 15ft (4.57m)
-40 to 185 degrees Fahrenheit (-40 to 85 degrees Centigrade)
165 MPH
ROHS
402