Installing The Antenna - Cisco 4G-ANTM-OM-CM Manual

Outdoor Panel Antenna for WiMAX 1.8, 2.5, and 3.8 GHz

3/4 in. open-end wrench

LMR-400-DB RF coaxial cable with N (m) to N (m) connectors

Coax seal
NOTE: This list does not include the tools and equipment required to assemble and erect the tower, mast, or other structure you
intend to mount your antenna on.

Installing the Antenna

Follow these instructions to install the antenna:
1. Choose the mounting configuration that you prefer.
1
NOTE: Your connector type, location and quantity might differ from what is shown.
2. Attach the antenna mount bracket to the back of the antenna by using two sets of flat washers, lock washers, and hex nuts.
Tighten the nut to a torque rating of 55 in-lbf (6.2 Nm).
Drain-hole locations
1
530