Advertisement
Running H/F 1
Running H/F 2
CAUTION: Do not locate the antenna near overhead power lines or other electric light or power circuits, or where it can come into contact with
such circuits. When installing the antenna, take extreme care not to come into contact with such circuits, because they may cause serious injury or
death. For proper installation and grounding of the antenna, please refer to national and local codes (for example, U.S.:NFPA 70, National Electrical
Code, Article 810, Canada: Canadian Electrical Code, Section 54). Statement 1052
CAUTION: This product is not intended to be directly connected to the Cable Distribution System. Additional regulatory compliance and legal
requirements may apply for direct connection to the Cable Distribution System. This product may connect to the Cable Distribution System ONLY
through a device that is approved for direct connection. Statement 1078
Installation Instructions
To install the Cisco 4G-ANTM-OM-CM antenna on a ceiling:
1.
Drill a 3/4" diameter hole in the ceiling where you want to mount the antenna.
2.
(Optional) Drill three pilot holes and insert the supplied screw anchors.
NOTE: You can secure the antenna in place using only the mounting nut. However, for additional support, you can also use the supplied
mounting screws. To use the mounting screws, you must first drill three pilot holes and insert the supplied screw anchors in place.
a.
Insert the antenna's cable and thread through the hole you drilled in Step 1 until the base of the antenna is flush with the ceiling.
b.
Using a pencil or pen, mark the screw positions on the ceiling.
c.
Remove the antenna from the ceiling.
d.
Using a 3/16" drill bit, drill three holes for the screw anchors.
e.
Properly insert the three screw anchors into the pilot holes.
3.
Insert the antenna's cable and thread through the hole you drilled in Step 1 until the base of the antenna is flush with the ceiling.
4.
From above the ceiling:
a.
Thread the supplied flat washer through the antenna's cable and thread.
b.
Thread the supplied spring washer through the antenna's cable and thread.
c.
Thread the supplied mounting nut through the antenna's cable.
d.
Attach the mounting nut to the antenna's thread by manually turning the nut clockwise until the antenna is secured in place.
e.
(Optional) Insert the mounting screws, then cover them with the white screw covers.
5.
Connect the antenna's cable to one of the supported extension cables.
To extend the coaxial cable included with your antenna, we recommend an ultra-low-loss coaxial cable for installation flexibility without a
significant loss in range. The following table lists insertion loss information about ULL extension coaxial cables available from Cisco.
Cisco Product Number
3G-CAB-ULL-20
3G-CAB-ULL-50
3G-CAB-LMR240-25
3G-CAB-LMR240-50
3G-CAB-LMR240-75
Cable Length
Frequency Range
20 ft (6 m)
500-2000 MHz
50 ft (15 m)
500-2000 MHz
25 ft (7.5 m)
2200 MHz
50 ft (15 m)
2200 MHz
75 ft (23 m)
2200 MHz
332
Insertion Loss
–1.50 dB, maximum
–3.50 dB, maximum
–3.50 dB, maximum
–6.90 dB, maximum
–10.50 dB, maximum
Advertisement
