Mounting On A Vertical Surface - Cisco 4G-ANTM-OM-CM Manual

Cisco Aironet 2.4-GHz/5-GHz 8-dBi Directional Antenna (AIR-ANT2588P3M-N)
Installing the Antenna
Figure 4 Attaching Antenna Assembly
1 Azimuth adjustment bolt
2 Lock washer
6. Adjust the position of the antenna to the desired azimuth and elevation angles and tighten all pivot hardware (2
places) to a maximum torque of 30 in-lbf (3.4 Nm). The bracket allows the antenna position to be adjustable to +/–45
degrees azimuth and +/–60 degrees elevation.
Note: Cisco recommends grounding the antenna. See

Mounting on a Vertical Surface

The antenna can be wall mounted. Hardware is not included for wall-mount installation.
To mount your antenna on a vertical surface:
1. Remove antenna and mount kit from packaging.
2. Attach antenna mount bracket to the back of the antenna as shown in
torque of 12 in. lbf (1.1 Nm).
3. Attach elevation adjustable bracket as shown in
4. Using the appropriate customer-supplied anchors and screws, attach the azimuth adjustable bracket to the wall as
shown:
3 2
1
4
3 1/4-in. flat washer
4 Hex nut
Grounding the Antenna, page
Figure 2 and loosely secure hardware.
233
235.
Figure 1, applying a maximum nut-tightening