Mounting On A Wall Or Ceiling - Cisco 4G-ANTM-OM-CM Manual

Cisco Aironet Four-Port Dual-Band Polarization-Diverse Antenna (AIR-ANT2513P4M-N)

Slotted screwdriver to tighten the screws on the hose clamps

A 5/16 in. (8mm) socket or box wrench
NOTE: The pole or mast must be rigid enough to hold the weight of the antenna plus the associated forces produced by wind
loads. In addition, the pole or mast must be structurally strong enough to withstand the clamping force of the hose clamps.
You may need the following tools and equipment, which are not provided:

A drill and drill bit

A pencil

Mounting on a Wall or Ceiling

Follow these steps to mount your antenna on a wall or ceiling.
1. Remove the antenna and bracket hardware from the shipping container.
2. Determine the mounting location for the antenna.
NOTE: The fasteners and mounting surface should be capable of maintaining a minimum pullout force of 150 pounds (68
kg) to support the weight of the antenna plus the potential wind loading on the antenna.
3. Attach the mounting bracket to the wall or ceiling using four screws or bolts and anchors through the holes on the bracket.
Figure 5 shows the wall-mount bracket.
Figure 5 Wall-Mount Bracket and Dimensions (in millimeters)
4. Assemble the bracket hardware as shown in Figure 6.
160
4 slotted holes
for hose clamps