Cisco 4G-ANTM-OM-CM Manual page 201

Cisco Aironet 2.4 GHz and 5 GHz Dual-Band Polarization-Diverse Directional Array Antenna (AIR-ANT2566D4M-R)
Obtain Documentation and Submit a Service Request
2. Orient the antenna correctly (note the arrow on the back of the antenna that indicates the top of the antenna). Use a
flat-blade screwdriver to loosen or tighten the fasteners at the azimuth and elevation- adjustment pivots.
3. Adjust the azimuth (side-to-side position) and elevation (up-and-down position) of the antenna. Loosen the adjustment
pivot bolts slightly to allow for adjustment.
The azimuth angle can be adjusted ±90 degrees
Use the azimuth and elevation markings on the articulating mounting arm and the flange brackets as a guide. See
1. After adjusting the antenna position, tighten the pivot bolts. Tighten all the bolts to not more than 30 lbf.in. (3.4 Nm).
2. Connect the antenna cables to the access point. The antenna ports are labeled A through D. Connect the antenna port A
to connector A on the access point, antenna port B to connector B on the access point, and so on.
For the recommended cable type, see
(Figure 7) and elevation can be adjusted ±55 degrees
Recommended Cable.
481
(Figure 8).
Figure 6.