Table of Contents
Advertisement
Cisco Multiband Panel Outdoor 3G Antenna (ANT-3G-PNL-OUT-N)
1
Note:
Your connector type, location and quantity might differ from what is shown.
2.
Attach the antenna mount bracket to the back of the antenna by using two sets of flat washers, lock washers, and hex nuts.
Tighten the nut to a torque rating of 55 in-lbf (6.2 Nm).
1
3
3.
Attach the elevation adjustable bracket to the mount bracket using two sets of carriage bolts, washers, lock washers, and
hex nuts. Position the bolts so the carriage bolt square holes are positioned on the inside. Do not tighten fully. Allow the
bracket to move freely.
Drain-hole locations
1/4"-20 hex nut
1/4"-20 flat washer
1
1
2
3
4
2
1/4"20 spring lock washer
4
Antenna mount bracket
311
Hide quick links:
Advertisement
Table of Contents
