Table of Contents
Advertisement
Chapter 1 Module Introduction
Module Configuration
The module is shipped from the factory with operational parameters set to factory
defaults. However, you will probably choose to configure the operating parameters
so that they are best suited for your application.
Parameter for the Prisma II EDR Transmitter may be configured only through the
corresponding Prisma II EDR Receiver module. See the receiver documentation for
details.
Configuration Summary
You can use the receiver to perform the following configuration tasks:
Enable or disable each transmitter channel
Force Mute
Force Alarm (to service redundant modules)
Select Master, Slave, or Single operation
Select attenuation level per channel
Select transmitter mode
Enable bandwidth limiting
Select the node or Prisma II transmitter to view
See the Cisco Prisma II EDR Receiver Installation Guide, part number OL-29646-01 for
detailed information on configuring this module.
16
OL-32414-01
Advertisement
Table of Contents
Troubleshooting
