Cisco 350 Series Administration Manual page 684

24
STEP 1
STEP 2
STEP 3
STEP 4
462
It is also possible to filter certain notifications. This can be done by creating a filter in the
Notification Filter page and attaching it to an SNMP notification recipient. The notification
filter enables filtering the type of SNMP notifications that are sent to the management station
based on the OID of the notification that is about to be sent.
SNMPv1.2 Notification Recipients
To define a recipient in SNMPv1,2:
Click SNMP > Notification Recipients SNMPv1,2.
This page displays recipients for SNMPv1,2.
Enter the following fields:
• Informs IPv4 Source Interface—Select the source interface whose IPv4 address will
be used as the source IPv4 address in inform messages for communication with IPv4
SNMP servers.
• Traps IPv4 Source Interface—Select the source interface whose IPv6 address will be
used as the source IPv6 address in trap messages for communication with IPv6 SNMP
servers.
• Informs IPv6 Source Interface—Select the source interface whose IPv4 address will
be used as the source IPv4 address in inform messages for communication with IPv4
SNMP servers.
• Traps IPv6 Source Interface—Select the source interface whose IPv6 address will be
used as the source IPv6 address in trap messages for communication with IPv6 SNMP
servers.
If the Auto option is selected, the system takes the source IP address from the IP
NOTE
address defined on the outgoing interface.
Click Add.
Enter the parameters.
• Server Definition—Select whether to specify the remote log server by IP address or
name.
• IP Version—Select either IPv4 or IPv6.
• IPv6 Address Type—Select either Link Local or Global.
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
SNMP
Notification Recipients