Properties - Cisco 350 Series Administration Manual

15

Properties

STEP 1
STEP 2
266
To enable Multicast filtering, and select the forwarding method:
Click Multicast > Properties.
Enter the parameters.
• Bridge Multicast Filtering Status—Select to enable filtering.
• VLAN ID—Select the VLAN ID to set its forwarding method.
• Forwarding Method for IPv6—Set one of the following forwarding methods for IPv6
addresses:
- MAC Group Address—Forward packets according to the MAC Multicast group
address
- IP Group Address—Forward packets according to the IPv6 Multicast group
address
- Source Specific IP Group Address—Forward packets according to the source IPv6
address and IPv6 Multicast group address. If an IPv6 address is configured on the
VLAN, the operational forwarding method for IPv6 Multicast will be IP Group
Address.
For IPv6 IP Group Address and Source Specific IP Group Address modes, the
NOTE
device checks a match only for 4 bytes of the destination Multicast address and for the
source address. For the destination Multicast address, the last 4 bytes of group ID are
matched. For the source address, the last 3 bytes + the 5th from the last byte are
matched.
• Forwarding Method for IPv4—Set one of the following forwarding methods for IPv4
addresses:
- MAC Group Address—Forward packets according to the MAC Multicast group
address
- IP Group Address—Forward packets according to the IPv4 Multicast group
address
- Source Specific IP Group Address—Forward packets according to the source IPv4
address and IPv4 Multicast group address. If an IPv4 address is configured on the
VLAN, the operational forwarding method for IPv4 Multicast will be IP Group
Address.
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
Multicast
Properties