Cisco 350 Series Administration Manual page 483

17
STEP 3
STEP 4
STEP 5
STEP 6
340
A caution message displays if you selected any other access profile, warning you that,
depending on the selected access profile, you might be disconnected from the web-based
configuration utility.
Click OK to select the active access profile or click Cancel to discontinue the action.
Click Add to open the Add Access Profile page. The page allows you to configure a new
profile and one rule.
Enter the Access Profile Name. This name can contain up to 32 characters.
Enter the parameters.
• Rule Priority—Enter the rule priority. When the packet is matched to a rule, user
groups are either granted or denied access to the device. The rule priority is essential to
matching packets to rules, as packets are matched on a first-match basis. The highest
priority is '1'.
• Management Method—Select the management method for which the rule is defined.
The options are:
- All—Assigns all management methods to the rule.
- Telnet—Users requesting access to the device that meets the Telnet access profile
criteria are permitted or denied access.
- Secure Telnet (SSH)—Users requesting access to the device that meets the SSH
access profile criteria, are permitted or denied access.
- HTTP— Users requesting access to the device that meets the HTTP access profile
criteria, are permitted or denied.
- Secure HTTP (HTTPS)—Users requesting access to the device that meets the
HTTPS access profile criteria, are permitted or denied.
- SNMP—Users requesting access to the device that meets the SNMP access profile
criteria are permitted or denied.
• Action—Select the action attached to the rule. The options are:
- Permit—Permits access to the device if the user matches the settings in the profile.
- Deny—Denies access to the device if the user matches the settings in the profile.
• Applies to Interface—Select the interface attached to the rule. The options are:
- All—Applies to all ports, VLANs, and LAGs.
- User Defined—Applies to selected interface.
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
Security
Management Access Method