Vlan Configuration Wizard - Cisco 350 Series Administration Manual

4
STEP 10
STEP 11

VLAN Configuration Wizard

STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
42
The default SNTP servers are defined by name, thus DNS must be configured
NOTE
and operational (DNS server configured and reachable). This is done in
- Manual SNTP Server—Select and enter the IP address of an SNTP server.
Click Next to view a summary of configuration that you entered.
Click Apply to save the configuration data.
This wizard assists in configuring VLANs. Each time you run this wizard, you can configure
ports membership in a single VLAN. The first steps are for Trunk port mode (where you
configure trunk ports tagged and untagged ports), and then you configure Access port mode.
Click Configuration Wizards > VLAN Configuration Wizard.
Click Launch Wizard and Next.
Select the ports that are to be configured as trunk port (by clicking with mouse on the required
ports in the graphical display). Ports that are already configured as Trunk ports are pre-
selected.
Click Next.
Enter the fields:
• VLAN ID—Select the VLAN you want to configure. You can select either an existing
VLAN or New VLAN.
• New VLAN ID—Enter the VLAN ID of a new VLAN.
• VLAN Name—Optionally, enter VLAN name.
Select the trunk ports that are to be configured as untagged members of the VLAN (by
clicking with mouse on the required ports in the graphical display). The trunk ports that are not
selected in this step becomes tagged members of the VLAN.
Click Next.
Select the ports are that to be the access ports of the VLAN. Access ports of a VLAN is
untagged member of the VLAN. (by clicking with mouse on the required ports in the graphical
display).
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
Configuration Wizards
VLAN Configuration Wizard
DNS Settings.