Cisco 350 Series Administration Manual page 310

12
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
STEP 1
STEP 2
254
• The voice flow is accepted if the MAC address can be learned by the Forwarding
Database (FDB). (If there is no free space in FDB, no action occurs).
Voice VLAN Workflows
The device default configuration on Auto Voice VLAN, Auto Smartports, CDP, and LLDP
cover most common voice deployment scenarios. This section describes how to deploy voice
VLAN when the default configuration does not apply.
Workflow1: To configure Auto Voice VLAN:
Open the Voice VLAN Properties
Select the Voice VLAN ID. It cannot be set to VLAN ID 1 (this step is not required for
dynamic Voice VLAN).
Set Dynamic Voice VLAN to Enable Auto Voice VLAN.
Select the Auto Voice VLAN Activation method.
If the device is currently in Telephony OUI mode, you must disable it before you
NOTE
can configure Auto Voice Vlan
Click Apply.
Configure Smartports as described in the
Configure LLDP/CDP as described in the
respectively.
Enable the Smartport feature on the relevant ports using the
Step 7 and Step 8 are optional as they are enabled by default.
NOTE
Workflow2: To configure the Telephony OUI Method
Open the VLAN Management > Voice VLAN > Properties page. Set Dynamic Voice VLAN
to Enable Telephony OUI.
If the device is currently in Auto Voice VLAN mode, you must disable it before
NOTE
you can enable Telephony OUI.
Configure Telephony OUI in the
page.
Common Smartport Tasks
Discover - LLDP
Telephony OUI Table
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
VLAN Management
section.
and Discovery - CDP
Interface Settings page.
page.
Voice VLAN
sections,