Cisco 350 Series Administration Manual page 265

Managed switches

Hide thumbs Also See for 350 Series:

Table of Contents

All Wireless Access Points—Reapplies the macros to all interfaces defined as access

To reapply the Smartport macros associated with a specific interface, select that

interface (it must be UP) and click Reapply to reapply the last macro that was applied

to the interface.

The Reapply action also adds the interface to all newly-created VLANs.

Smartport Diagnostic.

If a Smartport macro fails, the Smartport Type of the interface is Unknown. Select an interface

which is of unknown type and click Show Diagnostic. This displays the command at which

application of the macro failed. See the workflow area in

troubleshooting tips. Proceed to reapply the macro after correcting the problem.

Resetting all Unknown interfaces to Default type.

Select the Smartport Type equals to checkbox.

Select Unknown.

Click Reset All Unknown Smartports. Then reapply the macro as described above.

This performs a reset on all interfaces with type Unknown, meaning that all interfaces

are returned to the Default type. After correcting the error in the macro or on the current

interface configuration or both, a new macro may be applied.

Resetting the interface of unknown type does not reset the configuration performed by the

macro that failed. This clean up must be done manually.

To assign a Smartport type to an interface or activate Auto Smartport on the interface:

Select an interface and click Edit.

Enter the fields.

Interface—Select the port or LAG.

Smartport Type—Displays the Smartport type currently assigned to the port/LAG.

Smartport Application—Select the Smartport type from the Smartport Application

Configuring Smartport Using The Web-based Interface

Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4

Common Smartport Tasks

Show Quick Links

Table of Contents