Cisco 350 Series Administration Manual page 255

Managed switches
Hide thumbs Also See for 350 Series:
Table of Contents

Advertisement

11
NOTE
200
Status is enabled, the interface configuration is retained. If not, the Smartport Type
reverts to Default.
Enabling Auto Smartport
Auto Smartport can be enabled globally in the
Enabled—This manually enables Auto Smartport and places it into operation
immediately.
Enable by Auto Voice VLAN—This enables Auto Smartport to operate if Auto Voice
VLAN is enabled and in operation. Enable by Auto Voice VLAN is the default.
In addition to enabling Auto Smartport globally, you must enable Auto Smartport at the desired
interface as well. By default, Auto Smartport is enabled at all the interfaces.
See
Voice VLAN
for more information on enabling Auto Voice VLAN
Identifying Smartport Type
If Auto Smartport is globally enabled (in the
Interface Settings
page), the device applies a Smartport macro to the interface based on the
Smartport type of the attaching device. Auto Smartport derives the Smartport types of
attaching devices based on the CDP and/or LLDP the devices advertise.
If, for example, an IP phone is attached to a port, it transmits CDP or LLDP packets that
advertise its capabilities. After reception of these CDP and/or LLDP packets, the device
derives the appropriate Smartport type for phone and applies the corresponding Smartport
macro to the interface where the IP phone attaches.
Unless Persistent Auto Smartport is enabled on an interface, the Smartport type and resulting
configuration applied by Auto Smartport is removed if the attaching device(s) ages out, links
down, reboots, or if the attached device receives conflicting capabilities. Aging out times are
determined by the absence of CDP and/or LLDP advertisements from the device for a
specified time period.
Using CDP/LLDP Information to Identify Smartport Types
The device detects the type of device attached to the port, based on the CDP/LLDP
capabilities.
Properties
Properties
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
page in the following ways:
page), and at an interface (in the
Smartport
Auto Smartport

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents