IP Configuration
IPv4 Management and Interfaces
STEP 3
STEP 4
STEP 5
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
•
IP Address Type—The available options are:
-
DHCP—Received from DHCP server.
-
Static—Entered manually. Static interfaces are non-DHCP interfaces that created
by the user.
-
Default—The default address that exists on the device by default, before any
configurations have been made.
•
IP Address—Configured IP address for the interface.
•
Mask—Configured IP address mask.
•
Status—Results of the IP address duplication check.
-
Tentative—There is no final result for the IP address duplication check.
-
Valid—The IP address collision check was completed, and no IP address collision
was detected.
-
Valid-Duplicated—The IP address duplication check was completed, and a
duplicate IP address was detected.
-
Duplicated—A duplicated IP address was detected for the default IP address.
-
Delayed—The assignment of the IP address is delayed for 60 second if DHCP
Client is enabled on startup in order to give time to discover DHCP address.
-
Not Received—Relevant for DHCP Address. When a DCHP Client starts a
discovery process, it assigns a dummy IP address 0.0.0.0 before the real address is
obtained. This dummy address has the status of "Not Received".
Click Add.
Select one of the following fields:
•
Interface—Select the port, OOB port, LAG, Loopback or VLAN as the interface
associated with this IP configuration, and select an interface from the list.
•
IP Address Type—Select one of the following options:
-
Dynamic IP Address—Receive the IP address from a DHCP server.
-
Static IP Address—Enter the IP address.
If Static IP Address was selected, enter the following fields:
•
IP Address—Enter the IP address of the interface.
•
Mask
16
285