Software Auto Synchronization In Stack - Cisco 350 Series Administration Manual

8

Software Auto Synchronization in Stack

129
Connecting Units
Two units can only be connected in a stack if the stack ports on both ends of the link are of the
same speed. You must check that both ports support the same speed.
Cables Types
The following describes the cable types supported.
Connector Type
Cisco SFP-H10GB-CU1M – Passive Copper Cable
Cisco SFP-H10GB-CU3M – Passive Copper Cable
Cisco SFP-H10GB-CU5M – Passive Copper Cable
Cisco SFP-10G-SR
Cisco SFP-10G-LRM
Cisco SFP-10G-LR
1G SFP Module MGBSX1
1G SFP Module MGBT1
1G SFP Module MGBLX1
1G SFP Module MGBBX1
100Mbs SFP Module MFELX1
100Mbs SFP Module MFEFX1
100Mbs SFP Module MFEBX1
Other SFPs
All the units in the stack must run the same software version. Each unit in a stack
automatically downloads firmware from the master unit, if the firmware, which the unit and
the master are running, is different. The unit automatically reboots itself to run the new
version.
Stack Ports or Network Ports
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
Administration: Stack Management
Software Auto Synchronization in Stack
All ports
1G - 10G
1G - 10G
1G - 10G
10G
Not supported
10G
1G
1G
1G
1G
Not supported
Not supported
Not supported
1G